2003 Chevy Impala Blend Door Actuator

2003 Chevy Impala Blend Door Actuator. The driver side actuator is located under the driver side of the dash to the right of the steering column.you can check actuator by looking at the center of the actuator while adjusting the temp. Look up see 2 screws remove them and the panel they hold on.

Dorman® Chevy Corvette 20052011 HVAC Heater Blend Door
Dorman® Chevy Corvette 20052011 HVAC Heater Blend Door from www.carid.com

The temperature blend door actuator is located on the right side of the transmission hump under the evap. The acdelco units are what i used on my 07 impala ss. It is so small that you could easily fit it in one hand if you were attempting to remove it.

An Air Blend Door Actuator Is Constructed From A Plastic Housing, A Small Electric Motor And A Plastic Gear Set.


The best part is, our chevrolet impala air blend door actuator products start from as little as $37.99. From full cold to full hot and back.the center should move left to right to adjust the door.you need to remove the trim panel under the dash first then remove the knee. After removing the clips, press the tab on the wiring connector and pull it off.

Press The Wiring Connector Tab, Remove The Clips And Pull It Off.


2003 chevrolet impala a/c heater blend door actuator. Cant find the blend door actuator on 2003 ford f150 super crew. Take out the blend door actuator.

I Agree, The Control Module Is The Resistor Pack (Or The Equivalent Of It).


Look to left main wire harness needs to be moved to the right , up and behind it is th blend actuator 7/32 socket to remove it. Equip cars, trucks & suvs with 2003 chevrolet impala a/c heater blend door actuator from autozone. Remove the blend door actuator:

Fits The Following Chevrolet Impala Years:


Helpful ( 0) not helpful ( 0) add a comment. The temperature blend door actuator is located on the right side of the transmission hump under the evap. Buy the kit on amazon prime:

Chevrolet Impala Blend Door Actuator Part Number:


3.6 out of 5 stars 3. I found a way to fix the actuators that cause this problem (in certain cases). Temperature is regulated by the blend air door and blend door actuator.